A list of the contents of this article:

The hair on the pork skin, how to remove it quickly?

1. | 660 grams of fresh pigskin, wash. 2 | put it on the board and use a knife to remove the fat and grease from the skin. Be sure to remove it clean. It is not only good for health, but also the key to make the finished product crystal clear and taste good. 3 | after the surface of the meat skin is cleaned, rinse thoroughly, then boil it in boiling water until the chopsticks can be inserted slightly, and then you can fish it out. 4 | the meat skin is covered with cold water and then sprinkled with salt.

2. Bake with open fire. Cut a small hole with a knife at both ends of the pigskin, insert a chopstick, hold the chopsticks in hand, straighten the pigskin, turn on the gas stove or natural gas stove, turn on the small fire, the hairy side down, roast, and instantly the pig hair melts. Scrape with a knife. Find out the sharpest knife at home, stretch one end of the pigskin in your left hand, scrape it with the knife in your right hand, and rinse the pork skin with water after scraping.

3. At this time, we can easily remove the surface of pig hair with tweezers, and do not leave the root of the hair. If it is not cooked, the skin will be elastic and cannot be pulled out with tweezers. This method of scalding pig skin is often used by cooks, which is suitable for: Wuhua pork has less hair and cannot be clamped with tweezers. The method is: cut the pork into small pieces, heat the pot, put the pigskin into the pot, press it with your hands until the pigskin changes color, so that the pigskin becomes clean.

Step 1: first of all, wash the pork without any seasoning. Heat the pot, keep the pigskin close to the pan noodles, move repeatedly, use high temperature to scald the pig hair, it only takes two minutes, the pigskin surface is yellowish, the hair is basically shedding. Then, gently scrape off the scorched pig hair with a knife, this method is both convenient and time-saving, pig skin scalding is also more fragrant, killing two birds with one stone.

How to scrape the oil off the pigskin?

1. A bubble: this is a step that is easy to ignore. Use the meat and skin as soon as you take it. Be sure to soak in clean water for two hours, which is beneficial to the next step of scraping oil and hanging skin. The meat skin is not so stiff and easy to operate; as soon as it is cleaned, scrape off the pig hair, oil and dirt from the skin with a kitchen knife before it is put into the pot.

2. Fried pig skin: material: pig skin, vegetable oil method: wash pig skin and put it into a pot of clean water, boil it over low heat to make the skin thicker and change color. Remove the boiled pig skin and let it cool. Scrape the grease off the meat skin with a knife. Cut the pigskin with a knife into long strips 5 cm wide, thread it up and hang it in a cool, ventilated place to dry.

3. Salt rubbing method: sprinkle a layer of edible salt on the pigskin and gently rub the surface of the pigskin with your hands. Salt grains can play a role in frosting and help remove grease. After kneading for a period of time, rinse off with clean water. Vinegar soaking: soak the pig skin in warm water mixed with white vinegar, which can help break down the oil and make it easier to remove. The soaking time depends on the thickness of the pigskin, usually about 15-30 minutes.

Is there any good way to remove the pig hair from the pigskin?

1. Tweezers plucking: when pig hair is not a lot, you can directly use small tweezers to clamp and pluck. Rice plucking: you can find complete rice with husk in the rice, press the rice close to the edge of the pig hair, press the grain and pig hair with your hands, and gently roll to remove the pig hair easily. Rosin hair removal. Heat the rosin and melt it, then apply it to a place where pig hair is denser, and when it dries, you can easily pull out the pig hair that sticks to it.

2. Plucking with tweezers: when there is less pig hair, small tweezers can be used for plucking one by one. Using rice to pluck: look for complete rice with husk, press and hold it close to pig hair, and gently roll the rice to pull out pig hair. Use the rosin hair removal method: heat the rosin to the melting state and apply it to the dense area of pig hair. after it is dried, the pig hair will adhere to the rosin and be pulled out easily.

3, clever trick 2: use tweezers to pull out slowly, although this is more time-consuming, but the effect is also the best, there is a special plucking forceps for chicken, duck and pork on the Internet, which is easier to use. You can also use ordinary tweezers. The so-called slow workers can do fine work, plenty of time, and especially care about pig hair friends, can use this method. Of course, this method is most suitable for cases where there is not much hair on the pork skin.

4. In the case of less pig hair, it can be shaved off with a razor. You can also burn the pigskin with hair over the fire, the hair will turn to ash as soon as it touches the fire, but the pigskin is still intact. Or burn the bottom of the pot red, put the pig skin with hair on the pot and burn it. The high temperature can burn off the pig hair in a short time.

How to depilate pigskin?

Rice plucking: you can find complete rice with husk in the rice, press the rice close to the edge of the pig hair, press the grain and pig hair with your hands, and gently roll to remove the pig hair easily. Rosin hair removal. Heat the rosin and melt it, then apply it to a place where pig hair is denser, and when it dries, you can easily pull out the pig hair that sticks to it. Burn pig hair. Turn on a small fire with gas to burn off the hair on the pigskin, which will be clean after cleaning.

In the case of less pig hair, it can be shaved off with a razor. Burning with fire is a quick and clean way to remove pig hair. Keep the fire of the gas stove to a minimum, and then burn the hairy pigskin over the fire. as soon as it touches the fire, the hair turns to ash, but the pigskin is still intact. Scalding it with a pot is a little more troublesome than burning it with fire, but at least it won't burn.

Trick 2: use tweezers to pull out slowly, although this is more time-consuming, but the effect is also the best, there is a special plucking forceps for chicken, duck and pork on the Internet, which is easier to use. You can also use ordinary tweezers. The so-called slow workers can do fine work, plenty of time, and especially care about pig hair friends, can use this method. Of course, this method is most suitable for cases where there is not much hair on the pork skin.

Plucking with tweezers: when there is less pig hair, you can use tweezers to pull out one by one. Using rice to pluck: look for complete rice with husk, press and hold it close to pig hair, and gently roll the rice to pull out pig hair. Use the rosin hair removal method: heat the rosin to the melting state and apply it to the dense area of pig hair. after it is dried, the pig hair will adhere to the rosin and be pulled out easily.

Pig skin depilation method: method 1: when burning the pig skin in the pot, you can put the iron pot on the fire and change the fire into a small fire, then use a clip or chopsticks to hold the pig skin with hair, put the pig skin into an iron pot and wipe it repeatedly, and finally use a kitchen knife to scrape back and forth on the pig skin surface to easily remove pig hair.

In the case of not much hair, you can use tweezers one by one clip. No matter how little the hair is, the method of workload is quite huge, and it especially tests patience and eyesight. If you use this method, you must find a helper. Turn on the natural gas stove at home, turn it on to a small fire, and burn pig hair, of course, the hair follicles of pig hair must be left in the pigskin.

The best way to depilate pigskin _ how to depilate pigskin

1. In general, pig hair removal is done by scalding and shaving with hot water, which can remove pig hair. Prepare a pot of cold water, add some baking soda to the boil, put the pigskin directly in, take it out after ironing, use the home grinding wheel, or broken tiles, ceramic tiles, whatever, polish it on the pigskin, it is very easy to use, the pig hair inside is also out, it is very clean, and the tools are easy to find.

2. To find a grain of rice, you must have a grain with a shell. In general, it is easier to get at home in rural areas. Put the rice on the furry pigskin. Hold the rice next to the pig skin in your hand and clamp the pig hair tightly in the middle. If the hand is pulled out a little harder, the pig hair will fall off easily. After plucking one hair, pull out the other pig hairs in the same way until you have finished.

3. If you have tweezers at home, you can use tweezers to pull out pig feathers one by one, or use girls' eyebrow clips. Online, you can sell this kind of plucking forceps for chicken, duck and pork, which is easier to use. This method has the best hair removal effect, can be pulled out with hair follicles, the cleanest removal, but it is a waste of time, the so-called slow workers can do fine work, enough time, and especially care about pig hair friends, can use this method.

4, first scald with boiling water for a while, and when the stomata of the skin are opened, it is more convenient and clean to use eyebrow forceps to clip the hair. First bake it over the fire, then scrape it with a knife. First blanch the water, then turn on the LPG, turn on low or medium heat, and then slowly burn the hairy skin to the fire.

5. Another efficient method is to use a special pigskin depilation machine. This kind of machine usually uses a high-speed rotating brush head or grinding wheel, which can quickly and thoroughly remove the hair roots from the pigskin. Before use, the pigskin also needs to be cleaned and dried, and then operate according to the operation instructions of the machine. Generally speaking, just put the pigskin into the entrance of the machine, start the machine, and the hairy root can be finished in a few seconds.

6. The best way to remove the root of pigskin is to use a scraper or a special hair removal machine. It is necessary to remove the hairy root from the pigskin because it can affect the appearance of the food and may have bacteria and odors. The scraper method is a traditional method, which requires cleaning the pigskin and wiping off the moisture, then gently scraping off the hair roots against the direction of hair growth. Pay attention to the uniform force when using the scraper to avoid scratching the pigskin.